Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions page 41

for individual lines back to factory settings. To change pool assignments
without affecting other settings, use Pool Line Assignment (#207) and
Pool Extension Assignment (#314).
Adding New Pools
Use this section if your system is configured for Hybrid mode to create new pools.
If you add outside lines to your system for use in a new pool, use Dial Mode
(#201) if the new lines are rotary lines, Pool Line Assignment (#207) to assign
lines to the new pool, Pool Extension Assignment (#314) to assign the new pool
to specific extensions, Line Ringing (Centralized Telephone Programming) to
specify when the new pool will start ringing at each extension that has the pool,
and Pool Access Restriction (#315) to limit an extension's access to all the lines
in the new pool. Also use Automatic Line Selection (Centralized Telephone
Programming) to add the new pool to the extension's Automatic Line Selection
sequence.
Adding New Extensions
If you add an extension to your system, you can probably use Copy Settings
(#399) to copy the settings of an existing extension. If you wish to further adjust a
new extension's settings, see
Swapping Extensions
If a user changes location, but wants to keep the same extension number, you can
make the change easily by changing the connection at the control unit.
For example, if the users at extensions 29 and 32 switch offices, you can
disconnect the modular plugs from those extension jacks in the control unit. Then
reconnect the plug from 32 into extension jack 29 and the plug from 29 into
extension jack 32. Now the users can take their respective phones to their new
locations, keep the same extension numbers, and retain the phones' programmed
settings.
2-10
Programming
''Customizing Extensions'' on page 2-6.