Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions page 200

Programming
(See Figure 2-3 on page 2-23
s
such as
To program a Contact Closure button:
1. Press
10 or 11.
2. Enter the number of the extension to be programmed with this feature.
3. Press a programmable button, preferably one with lights.
4. Press
Closure 2).
5. Program another button for this extension or exit programming mode.
Using
System Phone
To activate a Contact Closure:
1. Press the programmed button or press
f 4 2
1) or
The green light is on steady.
2. If the Contact Closure Operation Type for that Contact Closure is set to
Toggle, repeat Step 1 to deactivate the Contact Closure.
The green light goes off.
Standard Phone
To activate a Contact Closure:
1. Pick up the handset to get an intercom dial tone.
2. Press
2).
3. If the Contact Closure Operation Type for that Contact Closure is set to
Toggle, repeat Steps 1 and 2 to deactivate the Contact Closure.
for the location of special programming buttons
e
and on system phones.)
f 0 0 s s c
f 4 1
(for Contact Closure 1) or
(for Contact Closure 2).
# 4 1
(for Contact Closure 1) or
at extension
f 4 2
(for Contact
f 4 1
(for Contact Closure
# 4 2
(for Contact Closure
Feature Reference
5-85