Problems With System Restore - Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions

Problems with System Restore

Display Shows "Insert Valid Card" in
System Programming Mode
Possible Cause: The system did not detect a valid Backup/Restore PC Card when
you tried to do a restore using Restore Programming (#125).
What to do: Power down the system, insert a valid Backup/Restore PC Card in PC
Card Slot 2 of the PARTNER ACS processor module, and reapply power to the
system. Restart the procedure.
Display Shows "Bad File - Try Again" in
System Programming Mode
Possible Cause: You attempted a restore and the file was corrupted.
What to do: Try Restore Programming (#125) again with a different backup file.
Remember to power down the system before you insert or remove
Backup/Restore PC Cards.
Display Shows "Empty File" in
System Programming Mode
Possible Cause: You selected a file named AUTO.****** or MAN.****** for the
restore. The file is empty; no backups have been stored in it yet.
What to do: Try Restore Programming (#125) again using a file created during a
backup procedure. Remember to power down the system before you insert or
remove Backup/Restore PC Cards.
Display Shows "Incompatible Versions" in
System Programming Mode
Possible Cause: You attempted to restore a file that was created with an
incompatible software release.
What to do: Try Restore Programming (#125) again using a backup file that was
created with the current software release.
Display Shows "Restore Failed-Try Again" for
Two Seconds in System Programming Mode
NOTE:
This display indicates that all system and telephone programming has
reverted to the default settings.
6-29
Troubleshooting