Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions page 58

Changing Programming Type
When you are in programming mode, you can move between System
Programming and Centralized Telephone Programming. To change to Centralized
Telephone Programming when you are in System Programming, press
c
Telephone Programming, press
Remote Programming
The system permits programming from a remote location using an auxiliary device
called the Remote Administration Unit (RAU). Remote programming requires the
installation of two RAUs—one at your site and one at the location from which the
programming is to be done. For more information about remote programming, see
the PARTNER Communications System Remote Administration Unit Installation
and Use guide.
. To move back to System Programming when you are in Centralized
c s
then .
Programming
2-27