Line Access Mode (#313) - Release 2.0; Or Later - Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions

Line Access Mode (#313) — Release 2.0

or later

Description
This procedure applies only to systems configured for Hybrid mode.
This System Programming procedure identifies individual extensions that are to
operate as key extensions even though the system is configured for Hybrid mode.
If an extension's Line Access Mode is changed to Key, individual lines can be
assigned to specific buttons on that extension's phone regardless of whether they
are part of a pool.
Related Features
When an extension is changed from Pooled to Key, any previously
n
assigned pool buttons are removed from the extension and Pool Access
Restriction (#315) is set to No Access. Additionally, the extension is
programmed with factory settings for Line Assignment (#301), Line
Access Restriction (#302), Automatic Line Selection, and Line
Ringing.
When an extension is changed from Key to Pooled, any previously
n
assigned line buttons are removed from the extension and Pool Access
Restriction (#315) is set to No Restriction. Additionally, the extension is
programmed with factory settings for Pool Line Assignment (#314), Pool
Extension Assignment (#314), Automatic Line Selection, and Line
Ringing.
Considerations
Extension 10 operates as a key extension regardless of how the system is
n
configured. The Line Access Mode for extension 10 cannot be changed.
Extensions that are programmed as key extensions cannot access pools
n
either by pressing pool buttons or by dialing pool access codes.
Valid Entries
1 = Pooled 4 all extensions except 10
2 = Key 4 extension 10 only
Programming
(See Figure 2-3 on page 2-23
s
such as and
To change the Line Access Mode setting for a specific extension:
for the location of special programming buttons
e
on system phones.)
5-163
Feature Reference