Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions page 298

To respond to a signal, the target extension must place an intercom call to
n
the person signaling.
Programming
(See Figure 2-3 on page 2-23
s
such as and
To program a Manual Signaling button:
1. Press
2. Enter the number of the extension to be programmed with this feature.
3. Press a programmable button.
4. Press
5. Dial the two-digit extension number of the target extension. For example, to
identify extension 22 as the target extension, press
extension number if you want to use the button for voice signaling.)
6. Program another button for this extension or exit programming mode.
Using
To beep the target extension:
n
1. While the handset is in the cradle, press the programmed button.
The extension beeps for as long as the button is pressed.
To ring or voice signal the target extension:
n
1. Lift the handset or press
2. Press
3. Press the programmed button.
To transfer a call to the target extension:
n
1. While active on the call, press
2. Press the programmed button.
for the location of special programming buttons
e
on system phones.)
f 0 0 s s c
at extension 10 or 11.
f 1 3
.
S
.
i
.
2 2
&
.
Feature Reference
*
. (Enter before the
5-183