Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions page 356

are already on a call. (You can store a Recall signal by pressing
if it is the first character stored.) It also includes a 1.5-second pause (which
you insert by pressing
3 2
.
Stop: Your local bank-by-phone service requires that you enter a password
n
before the account number. To program a Personal Speed Dial number or
an Auto Dial button to call the bank at 555-7898, include a stop for
manually entering the password, and continue with the account number
5 5 5 7 8 9 8! 6 7 9 8 8
(679 88), enter
Touch-Tone Enable: Your system is connected to rotary lines but you want
n
to call an answering machine at 555-3454 to retrieve messages. Since the
machine requires touch tones, enter
during the rest of the call are sent as touch tones.
On/Off Centrex Feature Button: To include both the activation and
n
deactivation codes for a Centrex feature on the same button, press
include a stop between the two codes. For instance, if the code to activate
a Centrex feature is *30 and the code to deactivate the feature is *31, store
* 3 0! * 3 1
on the Auto Dial button.
The first time you press the Auto Dial button, only the number before the
stop is dialed (to activate the feature). When you press the button again,
the rest of the stored number is dialed (to deactivate the feature).
Number Outside a PBX or Centrex System: To store a number that dials
n
out of a PBX or Centrex system, include a dial-out code in the Speed Dial
number. This entry, to dial the number 201 555-4321, includes a dial-out
code, a 1.5-second pause, and a toll call prefix of 1 for direct dialing (which
may not be required for your dialing area):
h
) to allow time to get a new Centrex dial tone:
.
5 5 5 3 4 5 4 &
9 h 1 2 0 1 5 5 5 4 3 2 1
S
, but only
S h *
. All digits pressed
!
to
5-241
Feature Reference