Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions page 396

Programming
(See Figure 2-3 on page 2-23
s
such as and
To program a Wake Up Service button at extension 10:
1. Press
2. At this point:
n
Wake Up Service Button
1 Assigned - Ext10
n
Wake Up Service Button
2 Not Assigned
n
Wake Up Service Button
3 Select a Button
3. Select another procedure or exit programming mode.
4. Label the Wake Up Service button at extension 10.
Using
To schedule a wake up call for a specific extension:
1. Press the Wake Up Service button at extension 10.
The green light next to the Wake Up Service button flutters. Wake Up
Service is activated and the display reads:
Wake Up Call
2. Dial the two-digit extension number of the desired extension (or use an
Auto Dial button). For example, to schedule a wake up call for extension
32, press 3 2. A display similar to the following appears:
Wake Up Call 32 -:-
3. Enter the wake-up time in 24-hour notation. For example, to set the time to
2:15 p.m., press
display reads:
Wake Up Call 32 14:15
for the location of special programming buttons
e
on system phones.)
f 0 0 s s # 1 1 5
at extension 10 or 11.
If you want to assign Wake Up Service to the first available button,
D
press until a display similar to the following appears:
If you want to remove the Wake Up Service button assignment,
D
press until a display similar to the following appears:
If you want to assign Wake Up Service to a specific button, press
A display similar to the following appears:
Then press a programmable button with lights to assign Wake Up
Service to that button.
1 4 1 5
. When you have finished entering the time, the
5-281
Feature Reference
3
.