Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions page 327

If you select Not Assigned (Setting 2) for the main pool (880) during Pool
n
Extension Assignment programming, the main pool is removed from the
two leftmost buttons on the bottom row of the system phone at that
extension. The buttons are then available for programming lines, auxiliary
pools, or system features. If the main pool is ever reassigned to that
extension, previous programming will be erased.
Auxiliary pool buttons will be located next to the main pool buttons unless
n
you select Setting 3 to choose a button location when programming.
You can assign up to four pools to a standard phone, but a single-line
n
phone can make only one call at a time. To make a call, the user lifts the
handset and dials
the Automatic Line Selection programmed for that extension. Alternatively,
the user can dial a pool access code to make a call using a specific pool.
Valid Entries
1 = Assigned 4 Main pool
2 = Not Assigned 4 Auxiliary pool
3 = Select Button (auxiliary pools only), then press a button to assign the auxiliary
pool to that button
Programming
(See Figure 2-3 on page 2-23
s
such as and
To assign pools to a pooled extension:
1. Press
2. Enter the system extension number to be programmed. For example, to
program extension 15, press
There is a steady red light next to each button that has a line assigned and
a flashing red light next to each button that has a pool assigned. To remove
all existing pool assignments, press
3. Enter the desired pool access code (880, 881, 882, or 883). For example,
to select pool 881, press
4. At this point:
n
Pool Ext Assign 15 P881
1 Assigned
n
Pool Ext Assign 15 P881
5-212
Feature Reference
9
; the system selects the first available pool based on
for the location of special programming buttons
e
on system phones.)
f 0 0 s s # 3 1 4
.
1 5
8 8 1
If you want to assign the pool to the first available button with lights,
D
press until a display similar to the following appears:
If you want to remove a pool assignment, press
similar to the following appears:
.
r
before selecting a pool.
.
D
until a display