Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions page 152

You must record the Automatic System Answer message from the system
display phone at extension 10 or 11.
You cannot record or play a message while Automatic System Answer or
Direct Extension Dial is answering a call. When you want to record or
play a message, turn off Automatic System Answer and Direct Extension
Dial and wait for any calls in the process of being answered by the system
to be completed.
Programming
(See Figure 2-3 on page 2-23
s
such as
To record an Automatic System Answer message:
1. The Automatic System/Direct Extension Dial PC card is purchased
separately and must be installed (see " PARTNER ACS PC Card
Installation Instructions ").
2. Turn off Automatic System Answer and Direct Extension Dial and wait
for any calls in the process of being answered by these features to be
completed.
3. Lift the handset of the system display phone at extension 10 or 11.
4. Press.
8 9 1
5. Dial
display for the duration of this procedure. The top line of the display reads:
ASA: 1=Record
If a message was recorded previously, a display similar to the following
appears:
ASA: 1=Record 2=Play
6. Press 1. A display similar to the following appears for three seconds:
Record at the tone
After three seconds, you hear a confirmation tone and you can begin
recording your message. While you are recording, a display similar to the
following appears:
Press # to stop
7. Press
If the allotted time (20 seconds) for the message is completed before you
press
recording.
When you finish recording, a display similar to the following appears:
ASA: 1=Record 2=Play
for the location of special programming buttons
e
and on system phones.)
. The current time of day remains on the second line of the
#
when you are done recording.
#
, you hear a tone to let you know that the system has stopped
5-37
Feature Reference