Clearing A Backup-Failure Alarm - Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions

Clearing a Backup-Failure Alarm

If you use Backup Programming—Automatic (#123) and the automatic backup
fails, a Backup-Failure Alarm message appears (instead of the default
day/date/time message) on the top line of the telephone display at idle extensions
10 and 11.
After correcting the problem that caused the failure, you can clear the
Backup-Failure Alarm using the following procedure. (See
2-23 for the location of special programming buttons such as
e
on system phones.)
1. Press
The current setting is displayed.
2. Press
NOTE:
You cannot use
3. Exit programming mode.
NOTE:
Using Option 3 to clear a Backup-Failure Alarm does not change the setting
for Backup Programming—Automatic (#123). It remains either Active or
Not Active.
f 0 0 s s # 1 2 3
3
to choose Option 3, "Backup Alarm Cleared."
D d
or
Figure 2-3 on page
s
in this procedure to choose Option 3.
Troubleshooting
and
.
6-7