Touch-Tone Enable (F08) - Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions

Touch-Tone Enable (F08)

Description
This feature is available only on system phones.
This feature lets a system phone user send touch-tone signals on an outside call
over a rotary line. For example, a user may need to dial touch-tone digits while on
a call to a bank-by-phone service.
Related Procedures
You must use Dial Mode (#201) to identify rotary lines to the system.
n
To activate this feature from within a number stored on an Auto Dial button
n
or as part of a Speed Dial number, press
''Special Dialing Functions'' on page
Considerations
This feature is needed only when dialing on a rotary line.
n
Use Touch-Tone Enable only after a call is connected. For example, use
n
this feature after dialing a bank-by-phone service that requires you to dial
touch-tone digits.
You can program a Touch-Tone Enable button on a system phone to turn
n
on Touch-Tone Enable with one touch.
Programming
(See Figure 2-3 on page 2-23
s
such as and
To program a Touch-Tone Enable button:
1. Press
2. Enter the number of the extension to be programmed with this feature.
3. Press a programmable button.
4. Press
5. Program another button for this extension or exit programming mode.
Using
From a system phone, press the programmed button or press
need to enter touch-tone digits. Touch-Tone Enable stays in effect until you hang
up.
5-260
Feature Reference
for the location of special programming buttons
e
on system phones.)
f 0 0 s s c
at extension 10 or 11.
f 0 8
.
&
when storing the number—see
5-240.
f
0 8 when you