Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions page 40

Changing the System Clock
You may need to change the system clock for daylight saving time, after a
prolonged power failure, or after a system reset. Use System Date (#101),
System Day (#102), and System Time (#103) to set the current date, day, and
time.
Adding New Lines
Key Extensions
Use this section to add individual lines to pooled extensions or to add new lines to
key extensions (all extensions in Key mode; in Hybrid mode, extension 10 and
any extensions set to Key using Line Access Mode (#301) are key extensions.)
If you add an outside line to your system, you may need to adjust some line
settings. In particular, use Dial Mode (#201) if the new line is a rotary line, Line
Assignment (#301) to assign the line to specific extensions, Line Ringing
(Centralized Telephone Programming) to specify when the line will start ringing at
each extension that has the line, and Line Access Restriction (#302) to limit an
extension's access to the line. Additionally, the system automatically assigns the
new line as the last line in the Automatic Line Selection sequence. If you want to
change the order, use Automatic Line Selection (Centralized Telephone
Programming).
NOTE:
Do not use Number of Lines (#104) if you add lines to the system after
initial setup, because it changes Line Assignment (#301), Line Access
Restriction (#302), Automatic Line Selection, and Line Ringing for
existing lines back to factory settings. To add a new line without affecting
other settings, use Line Assignment (#301).
Pooled Extensions
Use this section to add new lines to existing pools if your system is configured for
Hybrid mode. To assign a new line to a pooled extension as an individual line,
follow the procedures in "Key Extensions."
If you add an outside line to your system for use in an existing pool, use Dial
Mode (#201) if the new line is a rotary line and Pool Line Assignment (#207) t o
add the line to an existing pool.
NOTE:
Do not use Number of Lines (#104) if you add lines to the system after
initial setup, because it changes Pool Line Assignment (#207), Pool
Extension Assignment (#314), Pool Access Restriction (#315),
Automatic Line Selection, and Line Ringing for existing pools back to
factory settings. Additionally, it changes Line Assignment (#301), Line
Access Restriction (#302), Automatic Line Selection, and Line Ringing
2-9
Programming