Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions page 270

No hotline or alert extension assigned 4
Example
A supermarket installs a hotline phone at its meat counter. When a customer uses
the hotline phone, the butcher's phone rings. Alternatively, if the loudspeaker
paging system is programmed as the alert extension, a sales clerk could request
a "price check" over the loudspeaker simply by lifting the handset of the hotline
phone.
Programming
(See Figure 2-3 on page 2-23
s
such as and
To identify a hotline extension and its alert extension:
1. Press
2. At the Extension: prompt, enter the hotline extension number—see
"Valid Entries" on the previous page. For example, to program extension 33
as the hotline, press
3. At the Data - - - - - - - - - - - - prompt, enter the alert extension number—
see "Valid Entries" on the previous page. For example, to program
extension 32 as the alert extension, press
following appears:
Internal Hotline Ext 33
Data 32
4. At this point:
n
n
n
5. Select another procedure or exit programming mode.
Using
To use the hotline phone:
1. Lift the handset of the hotline phone.
The designated alert extension rings.
2. When the call is answered, speak into the handset.
for the location of special programming buttons
e
on system phones.)
f 0 0 s s # 6 0 3
at extension 10or 11 .
3 3
.
To change the hotline and alert extension numbers you just entered,
repeat Steps 2 and 3.
To delete the existing hotline and alert extension numbers, press
To identify another hotline and alert extension pair, press
the new hotline extension number shows on the display. Then
repeat Step 3.
3 2
. A display similar to the
n
or
Feature Reference
r
.
p
until
5-155