Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions page 162

Programming
(See Figure 2-3 on page 2-23
s
such as
To begin a manual backup of system settings:
1. Verify that only one Backup/Restore Card is in the processor module.
2. Press
10 or 11.
If there is a problem, one of the following messages is displayed:
Card is Write Protected
Insert Valid Card
System Busy
See Chapter 6,
Otherwise, the display instructs you to press Enter to begin the backup.
3. Press
A status message is displayed indicating that a backup is in progress, and
within 30 seconds, a message displays indicating the result.
If the backup was successful, the new backup information replaces the
information in the old MAN.mmddyy file on the Backup/Restore PC Card
and the.mmddyy extension now reflects the current date. Backup
information created during a manual backup does not overwrite any
AUTO.mmddyy file. Go on to Step 4.
If the backup failed, you see one of the following error messages in the
display:
Backup Failed:Check Card
Backup Failed:SystemBusy
Go to Step 4 and then see
and corrective actions.
4. Exit programming mode.
NOTE:
If you exit the procedure before the backup finishes, you will not
interrupt the backup, but you will not see feedback messages on the
display.
for the location of special programming buttons
e
and on system phones.)
f 0 0 s s# 1 2 4
''Troubleshooting'', for explanations and corrective actions.
e
.
Chapter 6,
at extension
''Troubleshooting'', for explanations
Feature Reference
5-47