Specifications - Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions

Specifications

Capacities
System
19 outside lines via line jacks on one
ACS processor module plus two 206
modules plus four 400 modules
40 extensions via extension jacks on
one ACS processor module plus four
308EC modules
1 loudspeaker paging system via
PAGE jack on ACS processor module
1 audio source via MUSIC ON HOLD
jack on ACS processor module (RCA
phono plug required)
1 call reporting device via SMDR jack
on ACS processor module (335 A/F
adaptor required)
1 Contact Closure Adjunct using
CONTACT CLOSURE jack on ACS
processor module
2 doorphones, using two extension
jacks
1 voice messaging system-PARTNER
MAIL VS, which uses a slot in the 2- or
5- Slot carrier, or PARTNER MAIL,
which connects to either 3 or 5
extension jacks
Module
ACS Processor Module
3 outside lines
8 extensions
2 touch-tone receivers
except when used with
308EC module
2 power-failure transfer
extensions
206 Module
2 outside lines
6 extensions
1 touch-tone receiver
1 power-failure transfer
extension
308EC Module
3 outside lines
8 extensions
6 touch-tone receivers
2 power-failure transfer
extensions
400 Module
4 outside lines
No extensions
2 touch-tone receivers
A
Extension Jack
Maximum two devices per
extension jack, total REN
on jack not to exceed 2.0
[System phone REN is
0.0(zero)]
Note: The two devices
combined on an extension
jack can be a system
phone with a standard
device, or two standard
devices.
DO NOT connect two
system phones to the
same extension jack. If a
device lists two RENs, use
the higher number when
adding up the RENs.
No more than one system
phone per jack
For programming, a
system display phone
must be connected to
extension 10 or 11.
A-1