Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions page 338

Valid Entries
1 = MAN. mmddyy 4 (where mmddyy = the month, day, and year)
2 = AUTO. mmddyy $&man[v]
Using
(See Figure 2-3 on page 2-23
s
such as and
To initiate a restore:
1. If you have a Backup/Restore PC Card installed, skip to Step 2. If you do
not have a PC Card installed, refer to the " PARTNER ACS PC Card
Installation Instructions ."
2. Press
The top line of the display shows Sys Set Restore or System
Settings Restore.
If no PC Card is present in the PARTNER ACS processor module, the error
message Insert Valid Card is displayed. Install a new PC Card using the
"PARTNER ACS PC Card Installation Instructions." Then repeat this
procedure from Step 2. You must power down the system before
removing or inserting a Backup/Restore PC Card.
You are prompted to choose the backup file you want to use for the restore.
The bottom line of the display shows 1 MAN.mmddyy , where mmddyy
represents the date of the manual backup on this card.
3. To change to the file created by an automatic backup, press
The bottom line of the display shows 2 AUTO.mmddyy, where mmddyy
represents the date of the automatic backup on this card.
NOTE:
If the date of the file (AUTO. mmddyy or MAN. mmddyy ) indicates
that this is not the file you intended to use, refer to the instruction
package with the PC Upgrade card for complete instructions on how
to install the Backup/Restore PC Card.
NOTE:
If the Backup/Restore PC Card is fresh from the factory, and no
backups have been recorded on it yet, the filenames will be
MAN.****** and AUTO.******, respectively. You cannot use
these files for a restore; they will generate the error message Empty
File after you press
4. Press
If the system detects an error before beginning the restore, the bottom line
of the display shows one of the following messages:
for the location of special programming buttons
e
on system phones.)
f 0 0 s s # 1 2 5
at extension 10 or 11.
e
in Step 4.
e
to start the restore.
2
.
5-223
Feature Reference