Changing Settings After Installation - Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions

Changing Settings after Installation

As your business grows or changes, you will probably need to change the way
your system was originally programmed. This section provides some examples
and lists the procedures you would use to change settings after installation. For
specific details on a procedure, refer to the procedure name in
I f you are upgrading to PARTNER A CS Release 1.1 or 2.0 or later from an earlier
release using the PC Card upgrade, all of your system programming settings will
be converted to work with the new release. However, you may want to consider
some additional programming for the features that are new in Release 2.0 or later.
The new programmable features are:
Automatic System Answer Button (#111)
Automatic System Answer Delay (#110)
Automatic System Answer Lines (#204)
Automatic System Answer Mode (#121)
Automatic System Answer Record/Playback (I891)
Call Coverage (F20, XX, XX)
Call Coverage Rings (#110)
Caller ID Call Log Line Association (#318)
Caller ID Log Answered Calls (317)
Direct Extension Dial Button (#113)
Direct Extension Dial Delay (#112)
Direct Extension Dial Lines (#205)
Direct Extension Dial Record/Playback (I892)
Pool Access Restriction (#315)
Pool Extension Assignment (#314)
Pool Line Assignment (#207)
SMDR Talk Time (#611)
PARTNER Voice Messaging PC Card (PARTNER ACS Release 1.1 or
later).
For more information about setting these features, see Chapter 5, ''Feature
Reference''.
For more information on using the PC Card Software Upgrade,
from PARTNER ACS Release 1.0 to Release 1.1 or Release 2.0 or Later'' on
page 2-28 in this section.
For more information on using the PARTNER Voice Messaging PC card, see
PARTNER Voice Messaging PC Card Installation, Programming and Use.
2-8
Programming
Chapter 5.
see''Upgrading