Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions page 55

Button Locations
When programming from a PARTNER-model phone at extension 10 or 11, keep in
mind that the button you press at the programming extension may be in a different
location on the phone to which the programming applies.
shows the relative location of buttons on each PARTNER-model phone. For
example, the button labeled E on the PARTNER-34D phone in
bottom row. The equivalent button on the PARTNER-18D phone is in the leftmost
position of the second row from the bottom. If your system has a mix of
PARTNER- and MLS-model phones, refer to Appendix E for information about
programming from a PARTNER-model phone to an MLS-model phone or from an
MLS-model phone to a PARTNER-model phone.
Programming Mode
1. Place the Programming Overlay over the dialpad of the system display
phone at extension 10 or 11—see
2-21 for more information.
2. To enter programming mode, press
following appears:
PROGRAM EXTENSION 10
(If you are programming from extension 11, "11" displays instead of "10.")
3. Press
10 Enter Extension Name
This display is for the Extension Name Display feature. When you are
entering System Programming mode, skip it by moving on to Step 4.
4. Press
SYSTEM PROGRAM
5. Specify a programming procedure in one of two ways:
6. To exit programming mode, you can press
off-hook, then place it back in the cradle.
2-24
Programming
s
. A display similar to the following appears:
s
again. A display similar to the following appears:
Direct Method : Dial the code for that procedure. System
Programming procedures in this guide are identified by a # and a
three-digit code (for example, System Date is #101). This method is
best when you are using only a few procedures during a
programming session and you know the codes.
Cycle Method : Cycle through the procedures in numerical order.
N
Press and
through the programming procedures. This method is best when
you are using multiple procedures during a programming session, or
if you do not know the codes.
Figure 2-4 on page 2-26
''The Programming Overlays'' on page
f 0 0
. A display similar to the
P
to cycle forward and backward
f 0 0
Figure 2-4 is in the
or lift the handset