Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions page 150

Use the Automatic System Answer Record/Playback feature to record a
message before using Automatic System Answer since there is no default
message.
If Automatic System Answer Mode is set to Hold, calls are placed on hold
at extension 10; however, any extension with access to the line on which
the call is held can retrieve the call.
If Automatic System Answer Mode is set to Hold and a call is placed on
hold for longer than one minute, the system generates a short Hold
Reminder Tone at extension 10. This tone sounds once every minute until
the held call is retrieved, or until the caller hangs up.
If Automatic System Answer Mode is set to Hold or Disconnect, you can
intercept a call while the message is playing—the light for the call will be
steady red. To intercept the call, press the line button and lift the handset.
The message stops playing when the call is retrieved.
If Automatic System Answer Mode is set to Ring, the line button on which
an outside call rings shows green flash continuously, even while the
system answers the call and plays the Automatic System Answer greeting.
To answer the call, lift the handset. If the message was playing, it stops
automatically.
Valid Entries
1 = Hold
2 = Disconnect
3 = Ring
Programming
(See Figure 2-3 on page 2-23
s
such as
To change the Automatic System Answer Mode:
1. Press
2. To change the mode, press
see "Valid Entries."
3. Select another procedure or exit programming mode.
for the location of special programming buttons
e
and on system phones.)
f 0 0 s s # 1 2 1
D
until the appropriate value displays—
Feature Reference
.
5-35