Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions page 320

(Recall), and
number assigned to any code
Programming
(See Figure 2-3 on page 2-23
s
such as and
To program Personal Speed Dial numbers:
1. Press
2. Dial the number of the extension to be programmed with this feature.
3. Select a two-digit code by pressing
99. For example, to select code 81, press
If a number is assigned already to the code, the number appears on the
display. If no number is assigned to the code, the display reads:
Blank
4. Enter the phone number exactly as you would dial it.
5. At this point:
n
n
n
6. Continue programming or exit programming mode.
Using
System Phone
You can lift the handset or press
1. If you want to call on a specific line, press the line button (or press
the two-digit line number) or if you want to call using a specific pool, press
the pool button (or press
2. Press
3. Dial the two-digit Personal Speed Dial code (80–99).
If you did not specify an outside line or pool, the system automatically
selects one, turns on the speaker if the handset is in the cradle, and dials
the number.
The number being dialed shows on a display phone.
&
(Touch-Tone Enable)—assigned to codes 80 through 99 No
4
for the location of special programming buttons
e
on system phones.)
f 0 0 s s c
at extension 10 or 11.
To program another Personal Speed Dial number, start from Step 3.
To program over an existing number, enter the new number after
selecting the two-digit code.
To remove a Personal Speed Dial number, enter the number's
two-digit code and press
S
before dialing:
i
and the three-digit pool access code).
f
.
f
and dialing two digits between 80 and
f 8 1
.
!
once.
Feature Reference
i 8
and
5-205