Contact Closure Group (#612) - Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions

Contact Closure Group (#612)

Description
The PARTNER ACS processor module has a jack to connect a Contact Closure
Adjunct that has two Contact Closures. This System Programming procedure
allows you to specify which user extensions can activate each Contact Closure.
The Contact Closures can control devices such as electronic door locks.
Related Features
Use Contact Closure Operation Type (#613) to specify how long each
Contact Closure remains active when activated.
If a Contact Closure is used to control a door lock and a doorphone is
installed at that door, you may want to assign the extensions in the Contact
Closure Group to also be the Doorphone Alert Extensions (#606) for that
doorphone.
When a user's extension is included in the appropriate Contact Closure
Group, the user can then use Contact Closure to activate the contact
closure device.
Valid Entries
1 = Assigned to the Contact Closure Group
2 = Not Assigned to the Contact Closure Group
Programming
(See Figure 2-3 on page 2-23
s
such as
To assign extensions to a Contact Closure Group:
1. Press
10 or 11.
2. At the Contact Number: prompt, enter the number for the Contact Closure
(1 or 2). For example, to assign extensions to Contact Closure 1, press
3. At the Extension: prompt, enter the two-digit extension number that you
want to assign to this Contact Closure Group. For example, to assign
extension 14 to this group, press
4. To assign or unassign the extension, press
value displays.
5. At this point:
5-86
Feature Reference
for the location of special programming buttons
e
and on system phones.)
f 0 0 s s # 6 1 2
1 4
.
D
until the appropriate
at extension
1
.