Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions page 98

Before including the Talk field on call reports or changing the output format
to 24 digits, check the documentation shipped with the call accounting
device to verify that these options are supported.
If SMDR Talk Time (#611) is set to Active and SMDR Output Format
(#610) is set to 24 digits, the combined length of the fields for a call record
will be greater than the 80 characters supported by most printers. If call
records wrap around to the next line, reduce the font size or increase the
characters-per-inch setting for the printer. If necessary, change the SMDR
Output Format back to 15 digits.
In the event of a power failure, records of any calls in progress are lost.
Inside (intercom) calls are not recorded.
If you place a call on hold and the caller hangs up, the call is considered
complete and the record is sent to the call reporting device.
Conference calls appear as two outside calls. (This means two records are
generated on the report.)
Output Format
The following RS-232 serial transmission protocol is used for SMDR records:
1200 baud
No parity
8 data bits
2 stop bits
The call reporting feature also supports XON/XOFF protocol, carriage returns,
and line feeds.
Serial Printers
Use a 355A adapter, which converts a modular jack interface to an RS-232 25-pin
connector, to connect a serial printer to the PARTNER ACS processor module. If
you connect a printer, make sure the printer can receive SMDR data in the format
described above (refer to the printer's instructions or contact the printer's
manufacturer if you need help).
If SMDR Talk Time (#611) is set to Active and SMDR Output Format (#610) is
set to 24 digits, the combined length of the fields for a call record will be greater
than the 80 characters supported by most printers. If call records wrap around to
the next line, reduce the font size or increase the characters-per-inch setting for
the printer. If necessary, change the SMDR Output Format back to 15 digits.
Using Auxiliary Equipment
4-13