Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions page 135

PARTNER-6 phones have only four buttons available for lines, pools,
and/or Auto Dial numbers.
A combined total of 576 outside Auto Dial and Personal Speed Dial
numbers can be programmed.
For PBX or Centrex systems that require a dial-out code to make calls
outside the PBX or Centrex system, include the dial-out code followed by
one or more pauses (if available) on an Auto Dial button for a number
outside the PBX or Centrex system. (See
PBX or Centrex Services'' on page 2-11
Examples
The examples below show some possible entries for an Auto Dial number in Step
4 of "Programming."
Outside Phone Number. Enter the phone number (up to 28 digits) exactly
as you would dial it. For example, to program 555-2398, press
2 3 9 8
Extension Number. Press the left
extension number. Press
Auto Dial button to voice signal an extension. For example, to program
extension 20 for voice signaling, press * 2 0. The display reads:
Intercom *20
Feature Code. Enter the appropriate code. For example, to program a
button to turn on the message light at extension 20, press
0
. When you press the programmed button, the Message Light at
extension 20 turns on.
Programming
(See Figure 2-3 on page 2-23
s
such as
To program an Auto Dial button:
1. Press
10 or 11.
2. Enter the number of the extension to be programmed.
3. Press a programmable button.
4. Enter an outside phone number, feature code, account code, or
PBX/Centrex feature access code; or press left
extension number.
5. Repeat Steps 3 and 4 to program additional Auto Dial buttons, or exit
programming mode.
5-20
Feature Reference
.
*
before the extension number to program the
for the location of special programming buttons
e
and on system phones.)
f 0 0 s s c
''Changing Settings to Support
for more information.)
i
button and enter the two-digit
f 0 9 2
i
and enter an
5 5 5
at extension