Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions page 272

line covered by the PARTNER MAIL's Automated Attendant Service, the
PARTNER MAIL system recognizes that it is a fax call and automatically
transfers it to the first available fax machine in the group.
Considerations for Hunt Group 7
This Hunt Group is used exclusively for the extensions associated with the voice
messaging system hardware. Do not assign any other extensions to this group. A
voice messaging system requires special hardware and set up procedures—refer
to ''Voice Messaging Systems'' on page 4-27
with the voice messaging system for more information.
Valid Entries
1 = Assigned to group
2 = Not Assigned to group 4
Programming
(See Figure 2-3 on page 2-23
s
such as and
To assign extensions to a Hunt Group:
1. Press
2. At the Group: prompt, enter a group number (1–7). For example, to select
group 1, press
Hunt Group 1
Extension:
3. Enter the desired extension number. For example, to select extension 31,
press
4. To assign or unassign the extension, press
displays.
5. At this point:
n
n
6. Select another procedure or exit programming mode.
for the location of special programming buttons
e
on system phones.)
f 0 0 s s # 5 0 5
at extension 10 or 11.
1
. A display similar to the following appears:
3 1
.
To assign or unassign another extension, press
extension number shows on the display. Repeat Step 4.
To program another group, press
and repeat Steps 3 and 4.
and to the documentation shipped
D
until the appropriate value
n p
or until the
N P
, enter a new group number,
Feature Reference
5-157