Enable; Exit-Overflow-Interval - Dell PowerConnect 6224 Command Line Interface Manual

Example
The following example specifies the access list to filter routes received from
the RIP source protocol.
console(config-router)#distribute-list ACL40 out rip

enable

Use the enable command in Router OSPF Configuration mode to reset the
default administrative mode of OSPF in the router (active). Use the no form
of the command to disable the administrative mode for OSPF.
Syntax
enable
no enable
Default Configuration
Enabled is the default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example enables OSPF router mode.
console(config-router)#enable

exit-overflow-interval

Use the exit-overflow-interval command in Router OSPF Configuration
mode to configure the exit overflow interval for OSPF. When a router leaves
the overflow state it can originate non-default AS-external-LSAs. When set to
0, the router will not leave Overflow State until restarted. Use the no form of
the command to return the interval to the default value.
879
OSPF Commands