ABB IRB 6730 Product Manual page 269

9
Refitting the arm house cover including the cassette sealing
Use these procedures to refit the arm house cover including the cassette sealing.
Preparations before refitting the arm house cover
1
Refitting the arm house cover including the cassette sealing
1
2
3
Product manual - IRB 6730
3HAC085699-001 Revision: B
5.5.1 Replacing the arm house cover including the axis-4 cassette sealing
Action
Remove the tool from the arm house cover. The
tool on the tube shaft can stay fitted.
Action
Wipe clean all contact surfaces.
Action
Prepare the refitting tool by removing the middle
screw from the part of the tool designed as a
cross.
Fit the cross to the tube shaft with four M8 screws.
CAUTION
Center the cross on the tube shaft, to not damage
the sealing.
CAUTION
Tighten the screws so that the cross bottoms
firmly against the tube shaft, but make sure not
to damage the cassette sealing.
Fit the arm house cover to the arm house with
guidance from the two guide pins in the cover.
Tip
Secure the cover temporarily with two screws M6
on each short side, as support to hold the cover.
© Copyright 2023 ABB. All rights reserved.
Note
Note
Note
xx2100001265
xx2100001264
xx2100001269
Continues on next page
5 Repair
Continued
269