ABB IRB 6730 Product Manual page 251

6
Refitting the bearing, cradle
Use these procedures to refit the bearing in the cradle.
Refitting the shaft end and rear bearings
1
2
3
Product manual - IRB 6730
3HAC085699-001 Revision: B
5.4.3 Replacing the rear bearings on the balancing device
Action
Pull out the shaft end with bearing, sealing
and distance using the dismantle and
mounting tool, according to user instruc-
tions enclosed with the equipment.
xx0900000813
Go to the user instructions enclosed with
the press tool.
DANGER
Handling the tool incorrectly will cause
serious injury.
Read and follow enclosed user instructions
for the tool.
Action
Wipe clean all contact surfaces from resid-
ual grease and other contamination inside
the recess.
Foundry Plus:
Apply Mercasol on matching surfaces on
the axis and balancing device. See the fig-
ure.
Apply some grease in the hole for the
bearing in the cradle.
Note
Do not apply grease on surfaces with Mer-
casol.
© Copyright 2023 ABB. All rights reserved.
Note
Dismantle and mounting tool:
3HAC028920-001
User instructions are enclosed with the
tool.
Note
C
B
A
xx1400000367
A Mercasol (red dotted lines)
B Balancing device
C Shaft
Continues on next page
5 Repair
Continued
251