ABB OmniCore IRB 6740 Product Manual page 535

2
3
4
Refitting the axis-2 motor
1
2
Product manual - IRB 6740
3HAC085701-001 Revision: A
Action
Remove any old paint or flange sealant residues
or other contamination from the contact surfaces
on both the motor and the mating parts.
Tip
Remove flange sealant residues with Loctite 7200.
Then use Loctite 7063 for cleaning the mating
surface.
Apply a continuous bead of flange sealant, 1-2
mm wide, inside of the groove on the motor con-
tact surface.
Note
The purpose of the groove is to catch excess
sealant. No o-ring is used.
Remove the cover, if fitted to the new spare part
motor.
Action
Fit guide pins in opposite holes.
CAUTION
The weight of the motor is 22 kg
© Copyright 2023 ABB. All rights reserved.
5.9.2 Replacing the axis-2 gearbox
Note
Cleaning agent: Loctite 7200, Loc-
tite 7063
Flange sealant: Loctite 5800
xx2100000520
Note
Guide pin, M10x150: 3HAC15521-2
Always use guide pins in pairs.
xx2100000593
Continues on next page
5 Repair
Continued
535