ABB OmniCore IRB 6740 Product Manual page 125

6
7
8
9
10
Product manual - IRB 6740
3HAC085701-001 Revision: A
Action
Check the oil level.
Required oil level: 0-10 mm below oil plug
hole.
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the safe-
guarded space.
Add or drain oil, if required.
Refit the oil plug with a new o-ring.
DANGER
Make sure all safety requirements are met
when performing the first test run. See
run after installation, maintenance, or repair
on page 96.
© Copyright 2023 ABB. All rights reserved.
4.3.9 Inspecting the oil level in axis-3 gearbox
Note
Type of oil and total amount is detailed in
Technical reference manual - Lubrication
in gearboxes.
Further information about how to drain or
fill with oil is found in section
oil in axis-3 gearbox on page
O-ring, G 1/2": 3HAC061327-059
Tightening torque: 24 Nm.
xx2300000203
Test
4 Maintenance
Continued
Changing the
147.
125