ABB IRB 1010 Product Manual page 192

5 Repair
5.4.3 Replacing the axis 3-4 assembly unit
Continued
3
4
Pulling out the cable package from axis 5
1
2
3
4
5
Continues on next page
192
Action
Remove the axis-6 cable bracket.
CAUTION
Be aware of the cablings that are attached to the
cable bracket! The bracket cannot be removed
completely until the cablings are removed from
the plate.
Cut the cable straps.
Action
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
Wrap the connectors with the masking tape.
Remove the axis-5 cable protector.
Note
The screws to be removed are a little protruding
than others. Do not mix the screws.
Pull out the cable package in the direction as
shown in the figure.
Slip out the cable protector.
© Copyright 2022 ABB. All rights reserved.
Note
xx2200000033
xx2200000034
Note
xx2200000036
xx2200000037
Product manual - IRB 1010
3HAC081964-001 Revision: B