ABB IRB 1010 Product Manual page 159

Required tools and equipment
Equipment
Standard toolkit
Calibration tool box, Axis Calibra-
tion
24 VDC power supply
Special toolkit
Required consumables and wear parts
Consumable
Cable straps
Grease
Battery pack
Deciding calibration routine
Decide which calibration routine to be used, based on the information in the table.
Depending on which routine is chosen, action might be required prior to beginning
the repair work of the robot, see the table.
1
Product manual - IRB 1010
3HAC081964-001 Revision: B
Action
Decide which calibration routine to use for
calibrating the robot.
• Reference calibration. External cable
packages (DressPack) and tools can
stay fitted on the robot.
• Fine calibration. All external cable
packages (DressPack) and tools
must be removed from the robot.
If the robot is to be calibrated with refer-
ence calibration:
Find previous reference values for the axis
or create new reference values. These val-
ues are to be used after the repair proced-
ure is completed, for calibration of the ro-
bot.
If no previous reference values exist, and
no new reference values can be created,
then reference calibration is not possible.
If the robot is to be calibrated with fine
calibration:
Remove all external cable packages
(DressPack) and tools from the robot.
© Copyright 2022 ABB. All rights reserved.
5.3.2 Replacing the SMB unit
Article number Note
- Content is defined in section
Standard toolkit on page
3HAC074119-001 Delivered as a set of calibration
tools.
Required if Axis Calibration is the
valid calibration method for the
robot.
- Used to release the motor brakes.
3HAC071022-001 Includes M12 connector as-
sembly tool and Brake release
button assembly tool.
Article number Note
-
3HAC029132-001 FM 222
3HAC044075-001 Battery includes protection cir-
cuits. Only replace with the spe-
cified spare part or an ABB-ap-
proved equivalent.
Note
Follow the instructions given in the refer-
ence calibration routine on the FlexPendant
to create reference values.
Creating new values requires possibility to
move the robot.
Read more about reference calibration for
Axis Calibration in Product manual - IRB
4600.
5 Repair
Continued
324.
Continues on next page
159