Stop After X Products (Pre-Defined Print Stop) - Leibinger JET3 User Manual

Group 7

7.5.3.2 Stop after x products (Pre-defined print stop)

With the option <Stop after x Products> the amount of prints will be defined after
the LEIBINGER JET3 should release an automatic print stop.
If a print stop has been pre-defined the value is displayed in the status field
<Production Counter> of the main menu.
Attention! Before the re-start of the production, the production
counter has to be necessarily reset to get a correct result.
Proceeding:
Press the option <Stop after x Products> (2).
The window <Stop at x Products> (3) is faded in.
Change the value of the print stop counter with the Arrow buttons (4). The value
of the counter will be increased or reduced in single steps by pressing the
accordant buttons.
or
Click in the Counter display field (5). The Number block (6) opens for input.
Confirm the changed value by pressing on the button <Set> (7) or cancel the
process with the button <Cancel> (8).
The set print stop value is now displayed in the status field <Product Counter>
(9) of the main menu. For better visualization that a pre-defined print stop has
been defined, the field is displayed with a red frame.
Release R1.03e
Data/Programming
You will find further information regarding the working with
number blocks in the chapter Number block!
Page 116
LEIBINGER JET3