Error And Warning List - Leibinger JET3 UP Service Manual

Error and Warning List

Code - Nr Error text
2=Internal communication
2
error
3=Internal communication
error.
3
Too much data.
4=Internal communication
4
error
5=Internal communication
5
error
6=Internal communication
error.
6
Too much data.
7=Internal communication
7
error
Reason
Internal communication problem:
A CPU (RIP) has sent a message (identifier)
to a different CPU which is unknown.
Possibly, firmware, and software versions
are not compatible.
Internal communication problem.
Internal message at the receiver was too
large (currently 1MB)
Internal communication problem.
Single data packet doesn't fit in the length
(= transmission errors)
Internal communication problem.
Block transfer error (= transmission errors)
Get to large amount of data.
Internal communication problem:
A CPU (RIP) has sent a message (identifier)
to a different CPU which is unknown.
Solution
Carry out a software update
Carry out a software update
Check files on maximum size of 1
MB. fonts, graphics, or job
Read the script and interface
protocol documentation!
Reboot again the system.
Reboot again the system.
Reboot again the system.
Carry out a software update.
Change the controller board.
Remarks
If software update is without
success, please contact
LEIBINGER
If no success, please contact
LEIBINGER
If no success, please contact
LEIBINGER
If no success, please contact
LEIBINGER
If no success, please contact
LEIBINGER
See the service document
"Exchange the Controller board
JET3up"
If no success, please contact
LEIBINGER
31