Error Messages; Figure 152 Device Messages - Leibinger JET2NEO Manual

Group 9
Figure 152
Device messages
Warning messages
1 – Warning text
2 – Balance time (Count down timer)

9.3 Error messages

Error Error message
no.
5000 Charging electrode is dirty
5001 Phasing error
5002 Error of drop control
5003 Error of oscillator voltage
5020 HV-current too high.
Please check
plates for dirt or damp-ness.
5060 Overload of the charging
voltage amplifier.
1309 Ink return monitoring
JET2 neo
Malfunctioning/Trouble shooting
4
1
2
Reason of failure
Charging electrode is dirty.
Charging electrode is dirty.
Charging electrode is dirty.
Wrong frequency has been set.
Oscillator is defect.
Bad drop control point.
Charging electrode is dirty.
Wrong frequency has been set.
Oscillator is defect.
Dirt at the deflection plates.
deflection Dampness at the deflection
plates.
Overload of charging voltage
amplifier.
Error messages
3 – Error text
4 – Button <Confirm>
Workaround
Clean charging electrode
Clean charging electrode
Clean charging electrode
Change frequency
Exchange oscillator
Clean charging electrode
Change frequency
Exchange oscillator
Clean deflection plates
Dry deflection plates
Clean charging electrode
Page 257
4
3
Release R1.12 en