Intel 8XC196NT User Manual page 330

A19:16
(EPORT)
AD15:0
(Ports 4 and 3)
8XC196
Device
16-bit Bus
Figure 14-4. Multiplexing and Bus Width Options
After reset, but before the CCB fetch, the device is configured for 8-bit bus mode, regardless of
the BUSWIDTH input. The upper address lines (AD15:8) are strongly driven throughout the
CCB0 and CCB1 bus cycles. To prevent bus contention, neither pull-ups nor pull-downs should
be used on AD15:8. Also, the upper bytes of the CCB words (locations 2019H, 201BH, and
201DH) should be loaded with 20H. If the external memory outputs 20H on its high byte, there
will be no bus contention.
After the CCBs are loaded into the CCRs, the values of BW0 and BW1 define the data bus width
as either a fixed 8-bit, a fixed 16-bit, or a dynamic 16-bit/8-bit bus width controlled by the
BUSWIDTH signal. (The BW0 and BW1 bits are defined in Figures 14-1 and 14-2.)
If BW0 is clear and BW1 is set, the bus controller is locked into an 8-bit bus mode. In comparing
an 8-bit bus system to a 16-bit bus system, expect some performance degradation. In a 16-bit bus
system, a word fetch is done with a single word fetch. However, in an 8-bit bus system, a word
fetch takes an additional bus cycle because it must be done with two byte fetches.
If BW0 is set and BW1 is clear, the bus controller is locked into a 16-bit bus mode. If both BW0
and BW1 are set, the BUSWIDTH signal controls the bus width. The bus is 16 bits wide when
BUSWIDTH is high and 8 bits wide when BUSWIDTH is low. The BUSWIDTH signal is sam-
pled after the address is on the bus, as shown in Figure 14-5.
Bus Control
4-bit Extended Address
16-bit Multiplexed
Address/Data
INTERFACING WITH EXTERNAL MEMORY
Bus Control
4-bit Extended Address
A19:16
(EPORT)
8-bit Address High
AD15:8
(Port 4)
8-bit Multiplexed
Address/Data
AD7:0
(Port 3)
8XC196
Device
8-bit Bus
A3067-01
14-11