Pulse Transient Commands - Pacific Power Source LMX Series Operation Manual

8.7.12 PULSE Transient Commands

The command in this section control PULSE transients. Some of these commands have the
option to specify NORmal or SATurate.
SATurate mode:
NORmal mode:
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Query Syntax
Description
Returned Data Format
Query Example
Query Syntax
Description
Returned Data Format
Query Example
Query Syntax
Description
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
If a dwell time setting is out of limits, the dwell time will saturate to the
limit min/max and it will not trip an error.
If a dwell time setting is out of limits, an error will be generated and
the dwell time setting will not be modified.
[SOURce:]PULSe:COUNT <nr1>, <opt>
This command sets the pulse count or the number of pulses to
execute. Minimum time set value allowed is 1.
Count, Option: < NORmal | SATurate >
Default is NORmal if optional second parameter is omitted.
<nr1>, <cr>
PULS:COUNT 5
[SOURce:]PULSe:COUNT?
<nr1>
PULS:COUNT?
5.0000
[SOURce:]PULSe:COUNT:MINimum?
This command returns the minimum permissible set value for the
PULSE count.
<nr1>
PULS:COUNT:MIN?
0
[SOURce:]PULSe:COUNT:MAXimum?
This command returns the maximum permissible set value for the
PULSE count.
<nr1>
PULS:COUNT:MAX?
65535
[SOURce:]PULSe:COUNT:DEFault?
This command returns the default set value for the PULSE count.
<nr1>
PULS:COUNT:DEF?
1
LMX SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 298 of 463