Pacific Power Source LMX Series Operation Manual page 294

Query Syntax
Description
Returned Data Format
Query Example
Query Syntax
Description
Returned Data Format
Query Example
Query Syntax
Description
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Query Syntax
Description
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
[SOURce:]STEP:PHASe:FINal#:MINimum?
This command returns the minimum permissible set value of the final
STEP phase angle for selected phase #
<nr1>
STEP:PHAS:FIN1:MIN?
Query return values for MINimim, MAXimum and DEFault are dependent on
MODE and interdependent parameter value settings
[SOURce:]STEP:PHASe:FINal#:MAXimum?
This command returns the maximum permissible set value of the
final STEP phase angle for selected phase #
<nr1>
STEP:PHAS:FIN1:MAX?
Query return values for MINimim, MAXimum and DEFault are dependent on
MODE and interdependent parameter value settings
[SOURce:]STEP:PHASe:FINal#:DEF?
This command returns the default set value of the final STEP phase
angle for selected phase #
<nr1>
STEP:PHAS:FIN1:DEF?
Query return values for MINimim, MAXimum and DEFault are dependent on
MODE and interdependent parameter value settings
[SOURce:]STEP:PHASe:DELTa# < nr2 >, <cr>
This command sets the delta STEP phase angle for selected phase #
number. Only phase 1 (B) and 2 (C) are allowed.
Phase No., < NORmal | SATurate >
Default is NORmal if optional second parameter is omitted.
<nr1>, <cr>
STEP:PHAS:DELT1 240.0
[SOURce:]STEP:PHASe:DELTa#?
<nr1>
STEP:PHAS:DELT1?
240.0000
[SOURce:]STEP:PHASe:DELTa#:MINimum?
This command returns the minimum permissible set value of the
delta STEP phase angle for selected phase #
<nr1>
STEP:PHAS:DELT1:MIN?
Query return values for MINimim, MAXimum and DEFault are dependent on
MODE and interdependent parameter value settings
LMX SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 294 of 463