Csc Configuration Screen; Transient Settings Screen; Table 6-24: Available Slew Rate Settings Screen Soft Keys; Table 6-25: Available Csc Configuration Screen Soft Keys - Pacific Power Source LMX Series Operation Manual

SOFT KEY
Browse(SK1)
Recall (SK2)
Save (SK3)
Set (SK4)
Refresh (SK5)
6.7.5

CSC CONFIGURATION Screen

The CSC CONFIGURATION menu allows the Continuous Self Calibration mode to be
enabled. This feature is used to improve load regulation of the power source by continuous
measurement of the output phase voltage(s) and adjusting the internal set points as needed
to maintain close to zero load regulation. If the CSC is unable to get the output to the set
point, an error will be generated. This error can be disabled by unchecking the "Fault on
saturation" check box.
The soft keys on the CSC CONFIGURATION screen are listed in the table below
SOFT KEY
-
-
-
-
Back (SK5)
6.7.6

TRANSIENT SETTINGS Screen

The TRANSIENT SETTINGS screen defines operation of transient execution.

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
Description
Allows browsing for a particular register's content.
Recalls selected Register setup content
Saves setup to selected Register
Sets output to selected Register content
Return to previous screen

Table 6-24: Available SLEW RATE SETTINGS screen soft keys

Figure 6-20: CSC CONFIGURATION screen
Description
Return to previous screen

Table 6-25: Available CSC CONFIGURATION screen soft keys

LMX SERIES™ OPERATION MANUAL
Front Panel Operation
SECTION 6:
Page 145 of 463