Pacific Power Source LMX Series Operation Manual page 453

Error Source Code
Front panel 601
Front panel 602
Front panel 603
Front panel 604
Front panel 605
Front panel 606
Front panel 607
Front panel 608
Front panel 609
Front panel 610
Front panel 611
Front panel 612
Front panel 613
Front panel 614
Front panel 615
Front panel 616
Front panel 617
Front panel 618
Front panel 619

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
Category Error Message
Error Frequency is too high to
enable xfmr coupling.
Error Extended voltage range is
not allowed when
overload modes are
enabled.
Error Frequency is too high for
extended voltage mode.
Error Cannot change extended
voltage mode with output
enabled.
Error Cannot enable current
overload mode when
extended voltage range is
enabled.
Error Cannot enable extended
frequency when
extended voltage range is
enabled.
Warning Power limits were
reduced due to extended
frequency mode.
Warning Current limits were
reduced due to extended
frequency mode.
Error Setpoint out of range due
to extended frequency
mode.
Error Unable to update
setpoint because it is
outside the allowed range
of extended frequency
mode.
Error Error during power stage
firmware update.
Error Phase rotation is always
negative in UPC
compatible mode.
Error Cannot change split
phase mode with output
enabled.
Error Serial port flow control
not available in this unit.
Error Too many commands per
line.
Warning Resistive impedance was
automatically reduced.
Warning Inductive impedance was
automatically reduced.
Error Cannot change output
impedance state with
output enabled.
Error Cannot change output
impedance mode with
output enabled.
LMX SERIES™ OPERATION MANUAL
SECTION 12: Warnings & Error Messages
Possible Cause Resolution
Page 453 of 463