Iec413 Option Interharmonics Commands - Pacific Power Source LMX Series Operation Manual

8.7.13 IEC413 Option Interharmonics Commands

The following SCPI commands are used to generate interharmonics on the output of the power
soruce.
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Description
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Description
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
[SOURce:]INTHarmonic:FREQuency
Sets the frequency of the interharmonic voltage component for all
phases. The query format returns the active setting
Frequency
<nr2>
INTH:FREQ 470
[SOURce:]INTHarmonic:FREQuency?
Query format returns theinterharmonic frequency setting.
<nr2>
INTH:FREQ?
470.0000
[SOURce:]INTHarmonic:FREQuency:DEFault
Sets the default frequency of theinter harmonic voltage component
for all phases. The factory default setting is 1800 Hz.
Frequency
<nr2>
INTH:FREQ:DEF 90
[SOURce:]INTHarmonic:FREQuency:DEFault?
Query format returns the interharmonic frequency setting.
<nr2>
INTH:FREQ:DEF?
90.0000
[SOURce:]INTHarmonic:FREQuency:MAXimum?
Returns the maximum value for the interharmonic frequency setting
which is 10,000 Hz..
<nr2>
INTH:FREQ:MAX?
10000.0000
[SOURce:]INTHarmonic:FREQuency:MINimum?
Returns the minimum value for the interharmonic frequency setting
which is 15 Hz..
<nr2>
INTH:FREQ:MIN?
15.0000
LMX SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 309 of 463