Program Memory Screen - Pacific Power Source LMX Series Operation Manual

6.7.4

PROGRAM MEMORY Screen

The Program Memory menu allows saving and recalling of instrument setups in non-volatile
memory registers. Setups include all steady state parameters, limits, operating modes and
transient list if programmed.
There are 10 setup registers numbered from 1 through 10. Use the shuttle to select either
the Recall or Save field and press the shuttle to enter edit mode. Once the correct number is
selected, press ENTER to confirm.
Recall from register #
Save setup to register #
Power recall register #
The soft keys on the PROGRAM MEMORY screen provide access to additional functionality
as listed in the table below.

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
Figure 6-19: PROGRAM MEMORY screen
Recalls setup from selected register. If register is empty, an
error message will be displayed and no setting will be
recalled.
Note: If a register location is empty, an error message will
be displayed.
Saves setup in effect to selected register number. If this
register already contained a saved setup, it will be over-
written.
Determines which register number setup is recalled at
power-up. Using this feature, the user can determine the
power-on default settings of the power source.
LMX SERIES™ OPERATION MANUAL
Front Panel Operation
SECTION 6:
Page 144 of 463