Pacific Power Source LMX Series Operation Manual page 266

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Description
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
[SOURce:]WAVEFORM#:NAME
Set waveform for selected phase to the waveform name passed as a
parameter. If no waveform name parameter is specified, the query
format returns the name of the selected waveform. See
WAVEFORM#[:NAME] command.
1 – 16
<nr1>
WAVEFORM1 4
[SOURce:]WAVEFORM#:NAME?
<nr1>
SOUR:WAVEFORM1?
4
[SOURce:]WAVEFORM#:ALIAS
Analogous to the WAVEFORM#[:NAME] command but in place of the
waveform name, the waveform description is passed as a quoted
string.
Waveform description as quoted string.
<cr>
WAVEFORM1:NAME:BYALIAS "Triangle"
[SOURce:]WAVEFORM#:ALIAS?
Analogous to the WAVEFORM#[:NAME]? query command but in
place of the waveform name, the alias is returned as a string.
<cr>
WAVEFORM1:ALIAS?
Triangle
[SOURce:]WAVEFORM#:LOAD
Sets the waveform name (1 – 16) to be loaded for the selected phase
# for the next SWITCH command. If # is omitted, sets all available
phases to waveform name specified.
Note: The waveform LOAD command loads the selected phase's
waveform registers with the waveform data for the specified
waveform name but does not cause it to appear at the output until
the WAVEFORM:SWITCH command is received.
1 – 16
<nr1>
WAVEFORM2:LOAD 12
[SOURce:]WAVEFORM#:LOAD?
<nr1> or <nr1>,<nr1>,nr1>
WAVEFORM:LOAD?
1,12,1
LMX SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 266 of 463