Pacific Power Source LMX Series Operation Manual page 283

Query Syntax
Description
Returned Data Format
Query Example
Query Syntax
Description
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Query Syntax
Description
Returned Data Format
Query Example
Query Syntax
Description
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
[SOURce:]STEP:DWELL:MAXimum?
This command returns highest permissible set value for the STEP
dwell time setting.
<nr2>
STEP:DWELL:MAX?
Query return values for MINimim, MAXimum and DEFault are dependent on
MODE and interdependent parameter value settings
[SOURce:]STEP:DWELL:DEFault?
This command returns default set value for the STEP dwell time
setting.
<nr2>
STEP:DWELL:DEF?
0.0998
[SOURce:]STEP:RAMP <time>, <opt>
This command sets the ramp time of the step in seconds
Minimum time set value allowed is 0.0001 sec. (0.1 msec)
Time in seconds, Option: < NORmal | SATurate >
Default is NORmal if optional second parameter is omitted.
<nr2>, <cr>
STEP:MODE:RAMP 5, SAT
[SOURce:]STEP:RAMP?
<nr2>
STEP:RAMP?
5.0000, SAT
[SOURce:]STEP:RAMP:MINimum?
This command returns lowest permissible set value for the STEP ramp
time setting.
<nr2>
STEP:RAMP:MIN?
Query return values for MINimim, MAXimum and DEFault are dependent on
MODE and interdependent parameter value settings
[SOURce:]STEP:RAMP:MAXimum?
This command returns highest permissible set value for the STEP
ramp time setting.
<nr2>
STEP:RAMP:MAX?
Query return values for MINimim, MAXimum and DEFault are dependent on
MODE and interdependent parameter value settings
LMX SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 283 of 463