Table of Contents
Advertisement
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
8.9.9
Communication USB Commands
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Entire Contents Copyright
2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
SYSTem:COMMunicate:SERial:BITS
This command sets the number of data bits used for serial
communications. Available settings are 7 or 8
< 7 | 8 >
<nr1>
SYST:COMM:SER:BITS 8
SYSTem:COMMunicate:SERial:BITS?
<nr1>
SYST:COMM:SER:BITS?
8
SYSTem:COMMunicate:SERial:SBITs
This command sets the number of stop bits used for serial
communications. Available settings are 1 or 2.
< 1 | 2 >
<nr1>
SYST:COMM:SER:SBIT 2
SYSTem:COMMunicate:SERial:SBITs?
<nr1>
SYST:COMM:SER:SBIT?
2
SYSTem:COMMunicate:SERial:FLOWcontrol
This command sets the method of handshaking used for serial
communications. Available settings are Xon/Xoff or Hardware
handshake.
< 0 | OFF | 1 | ON >
<b>
SYST:COMM:SER:FLOW ON
SYSTem:COMMunicate:SERial:FLOWcontrol?
<nr1>
SYST:COMM:SER:FLOW?
1
SYSTem:COMMunicate:USB:VIRTualport[:ENABle]
This command enables USB device control using virtual comm driver.
< 0 | OFF | 1 | ON >
<b>
SYST:COMM:USB:VIRT ON
SYSTem:COMMunicate:USB:VIRTualport[:ENABle]?
<b>
SYST:COMM:USB:VIRT?
1
LMX SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 331 of 463
Advertisement
Table of Contents
