System Information Commands - Pacific Power Source LMX Series Operation Manual

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
8.9.2

System Information Commands

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Description
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
SYSTem:ERRor:POE
This command sets the Power on Error reporting mode. Returns
status of Power on Error setting as 1 (enabled) or 0 (disabled).
< 0 | OFF | 1 | ON >
<b>
SYST:ERR:POE ON
SYSTem:ERRor:POE?
<b>
SYST:ERR:POE?
1
SYSTem:BEEP
This command generates an audible beep at the front panel of the
power source.
None
n/a
SYST:BEEP
SYSTem:FW:FRONTPANEL:VERsion?
Returns the firmware revision for the front panel processor.
<cr>
SYST:FW:FRONTPANEL:VER?
2.0.0
SYSTem:FW:FRONTPANEL:APPS:VERsion?
Returns the firmware revision for the front panel application
program.
<cr>
SYST:FW:FRONTPANEL:APPS:VER?
2.0.0
SYSTem:FW:IO:VERsion?
Returns the firmware revision for the Auxiliary I/O board processor
on LMX-xA version power sources.
<cr>
SYST:FW:IO?
1.0.4
SYSTem:FW:POWER:VERsion?
Returns the revision number of the power source's power stages.
<nr2>-<nr2>
SYST:FW:POWER:VER?
81.0.0-77.1.0
LMX SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 316 of 463