Pacific Power Source LMX Series Operation Manual page 445

Error Source Code
Front panel 177
Front panel 178
Front panel 179
Front panel 180
Front panel 181
Front panel 182
Front panel 183
Front panel 184
Front panel 185
Front panel 186
Front panel 187
Front panel 188

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
Category Error Message
Error Cycle reset is always
enabled in UPC
compatible mode.
Error Command not available in
this unit model.
Error Digital output is being
used for transformer
option.
Error Unknown processor type
detected. Run unit
discovery to recover.
Error Undiscovered node
detected. Run unit
discovery to recover.
Error Incorrect parallel unit
count
Error Invalid processor type
Error Daisy chain invalid type
Error Undiscovered controller
node was detected.
Error No master front panel
was detected.
Error More than enabled
master controller is was
detected. Going to
inactive state.
Error One or more units are not
energized or have a
failure.
LMX SERIES™ OPERATION MANUAL
SECTION 12: Warnings & Error Messages
Possible Cause
Auxiliary unit not
recognized. One of more
auxiliary units were not
recognized during
discovery
An inconsistency was
detected in the unit
internal communication
network.
Setting conflict. Auxiliary
unit count does not
match expected count
setting
Auxiliary unit not
recognized
Error during discovery
An inconsistency was
detected in the power
source's internal
communication network.
Error during discovery.
No Master found
Error during discovery.
Too many masters
Error during discovery.
Error with one or more
Auxiliary units found
during discovery
Resolution
Check all parallel cables
between units. Run
parallel unit discovery
from System menu to
recover
Turn unit off, check
parallel cables if they
exist, and then turn unit
on. If problem recurs
contact customer service.
Check all parallel cables
between units. Run
parallel unit discovery
from System menu to
recover or adjust
expected count to match
actual no of units
Check all parallel cables
between units. Run
parallel unit discovery
from System menu to
recover
Check all parallel cables
between units. Run
parallel unit discovery
from System menu to
recover
Turn unit off, check
parallel cables if they
exist, and then turn unit
on. If problem recurs
contact customer service.
Check all parallel cables
between units. Run
parallel unit discovery
from System menu to
recover
Check all parallel cables
between units. Run
parallel unit discovery
from System menu to
recover
Check all parallel cables
between units. Make sure
all units are powered on.
Run parallel unit
discovery from System
menu to recover
Page 445 of 463