Table of Contents
Advertisement
10.10.14
Sanitize and Reboot
This screen allows the unit to be cleared of all user settings. This applies to waveforms, settings,
transients etc. The unit will be reset to factory default conditions.
The Reboot allows the power source to be rebooted (reset) without cycling AC input power.
10.11
Additional Functions
Additional function may be added over time through firmware updates that may not be covered
by this user manual revision. If so, check the Pacific Power website for update manual versions.
(
www.pacificpower.com
10.11.1 Sharing Options – FTP & SAMBA
The LMX supports a network based sharing feature. Two protocols. These can be enabled from
the Sharing Options screen.
Entire Contents Copyright
2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
).
LMX SERIES™ OPERATION MANUAL
LAN Interface Configuration
SECTION 10:
Page 428 of 463
Advertisement
Table of Contents
