Table of Contents
Advertisement
Settings and ranges are detailed in the table bellows.
CONTROL
CHANNEL A
CHANNEL B
CURSORS
RUN / STOP
TRIGGER
TIME BASE
OFFSET
MEMORY DEPTH
SAVE
Entire Contents Copyright
2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
Purpose
Input
Selects output phase and parameter to be captured on Channel A. Available
phase vary by model: (Phase A for Single phase, Phase A or B in Split phase,
Phase A, B or C in Three phase mode.
Attenuator
Sets input amplitude scaling from 1V/div to 200V/div. Also available is AUTO
scaling or channel OFF.
DC Offset
This setting sets DC Offset or AUTO for auto DC offset compensation.
Same as Channel A but for B Channel
Check
Check ON to display on screen cursors.
When Enabled, two cursors are displayed using dashed vertical lines. Cursors
are 1 and 2. Also shown is delta- T and 1/delta T. Use the mouse or touch
screen to move the cursors.
Zoom & Pan
Available selections are:
• Time
• CH A
•
CH B
Acquisition
The Green Run button is location in the lower left corner. A Stop button is
located right next to it. The Stop button will be enabled while an acquisition is
in progress. The acquisition status is shown to the right of the Stop button as
either:
• RUNNING
• WAITING TRIGGER
•
STOPPED
Acq. Mode
Available selections are SINGLE MODE or REPEAT MODE
Trigger Modes
Available Trigger mode selections are:
• UPDATE PHASE CROSSING
• OUTPUT ENABLE
• OUTPUT DISABLE
• FREQUENCY CHANGE
• VOLTAGE RMS CHANGE
• VOLTAGE DC CHANGE
• PHASE CHANGE
• WAVEFORM CHANGE
•
INTERHARMONIC CHANGE
Position
The trigger position can be set from 0% of vertical scale (left) to 100% of
vertical scale (right). The trigger position is indicated using a yellow diamond
on the time axis.
Time/div
Available time base settings range from 10 sec/div to 20 µsec/div. The
acquisition window is a function of this setting and the selected sample window
size.
Trigger Offset
Trigger offset time and be set from 0 msec to 99,999,999,999,999,980,000
msec
No of Samples
No samples acquires can be set from 100 Samples to 1M Samples
Image
Saves Scope Image to PNG image file. Destination is browser default download
directory.
Note: Only the waveform display area of the browser window is saved. To save the entire
screen, including all scope settings, use a screen capture utility instead.
Data
Saves scope data to CSV File. Destination is browser default download
directory.
LMX SERIES™ OPERATION MANUAL
LAN Interface Configuration
SECTION 10:
Page 406 of 463
Advertisement
Table of Contents
