Pacific Power Source LMX Series Operation Manual page 264

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual
[SOURce:]WAVEFORM#:LOAD
This command loads the currently selected waveform to the actual
output register of the controller causing it output the waveform on
the selected phase #.
1, 2, 3
<nr1>
WAVEFORM1:LOAD
[SOURce:]WAVEFORM#:LOAD? <nr1>
<nr1>, <cr>
SOURce:WAVEFORM1:LOAD? 1
1, Sine
[SOURce:]WAVEFORM:RESTORE
This command restores the first 16 waveforms registers by replacing
waveform 1 to 16 with the factory defaults. See section 0.
Note: This command is useful if waveforms 2 through 15 were
overwritten with user-defined waveforms.
None
n/a
WAVEFORM:RESTORE
None
[SOURce:]WAVEFORM#:SELect
This command selects a waveform by alias (name) or number. When
using the WAVEFORM:x commands, the ALIAS|NUMBER is not
passed as it uses the selected one. This is to avoid passing the
waveform number to every command
<ALIAS|NUMBER, OPT: ALIAS|NUMBER , OPT: ALIAS|NUMBER >
The first parameter is required. Additional optional waveforms or
numbers may be added when operating the source in 2 or 3 phase
mode. The waveform selection sequence by phase is A, B, C.
<cr> or <nr1>
WAVEFORM:SEL SINE
WAVEFORM:SEL 1,2,3
WAVEFORM:SEL 5
[SOURce:]WAVEFORM#:SELect?
<cr> or <nr1>
WAVEFORM:SEL?
1,1,1 (FORM 3)
WAVEFORM:SEL?
1,1 (FORM 2)
WAVEFORM:SEL?
1 (FORM 1)
LMX SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 264 of 463